Six-Axis Flight Simulator

A six axis civil aviation flight simulator: a motion cockpit with control column, pedals and throttle running Microsoft Flight Simulator 2020.

The unit is a cockpit shell mounted on a six axis motion platform. Platform travel, bump intensity, roll and pitch are tuned in Qubic Manager, the same tool that sets VR compensation, so the motion follows the aircraft rather than a fixed loop.

Controls and setup

  • Control column, rudder pedals and throttle are mapped to the aircraft in Microsoft Flight Simulator 2020.
  • Motion level, turbulence and roll/pitch range are adjusted per user and per scenario.
  • VR headsets can be attached, with compensation configured in Qubic Manager.
  • The cockpit needs a dedicated room with clearance for platform travel.

Session formats

  • Free flight: any of the 37,000+ airports in the simulator, flown with the full pre flight checks.
  • Time trials: timed legs against AI or other pilots, with the aircraft matched to the route.
  • Missions: rescue, cargo and navigation tasks flown at low altitude in poor weather.

A session is briefed, flown and debriefed on the same cockpit, so a venue can run timed slots without a second briefing area.

Briefing and staff flow

The session is briefed in the cockpit, so staff can walk a first time guest through the control column, pedals and throttle before the flight starts. The same seat is used for the debrief, which keeps the room free of a second briefing table and shortens the changeover between bookings.

Room and maintenance

  • Reserve a dedicated room with clearance for the full platform travel.
  • Keep the power point and network drop fixed; simulator and scenery updates run over the network.
  • Check the harness, seat and pedals before each day of operation.
  • Dust the cockpit screens and lenses as part of the daily opening routine.

Planning a flying session

A visit works best as a booked slot. Staff ask the guest to pick a scenario before sitting down — a free flight from one of the 37,000+ airports, a timed leg or a low altitude mission — then set the motion level, turbulence and roll and pitch range in Qubic Manager to suit a first time flyer or a regular. The briefing, the flight and the debrief all happen in the same seat, so changeover is a settings reset rather than a room change, and a VR headset can be fitted for guests who want the full cockpit view. A first flight is usually a short route with mild motion; returning guests move straight onto the time trials.